Posted on

Raspberry Pi RDP

So first we need to install some software on the Raspberry Pi, but don’t worry it is very easy!
  1. Start up your Pi to the terminal prompt.
  2. Type the following command “sudo apt-get install xrdp”
  3. If promoted enter your password (the default is “raspberry”)
  4. Type “Y” and press enter.
  5. This is now installing xrdp onto your Pi which is the software we are going to use for the remote desktop connection.  Wait for it to complete.
  6. Restart your Pi.  We are going to check that xrdp is going to start up automatically.
  7. When your Pi has booted to the command prompt look for [ ok ] Starting Remote Desktop Protocol server : xrdp sesman.  This shows you that xrdp is installed and automatically starting up on start up of your Pi
  8. The last step is to make a note of the IP address of your Pi which should also be displayed on the start up screen.  In my case below it is 192.168.1.9.  This is the address of your Pi on your network and what we will use to connect to your Pi from the second machine.
Posted on

Re: R7900P dropping internet requiring reset every few days

I know Netgear has lots of problems of their routers recently since December last year , mostly involving internet connection instability, and that defeat the purpose of routers. Just for the time being, my guess is that newer firmware causing the problems. For R7900P, I wonder if you can downgrade to, say, FW 1.1.4.6 or even 1.1.4.4 to see if the router stays stable?

https://community.netgear.com/t5/Nighthawk-WiFi-Routers/R7900P-dropping-internet-requiring-reset-every-few-days/m-p/1487559/highlight/true

Posted on

How to Create Copyright and Trademark Symbols via Keystrokes

  • For the Copyright symbol (©) Hold the Alt key down and type 0169.
  • For the Trademark symbol (TM) Hold the Alt key down and type 0153.
  • For the Registered symbol (®) Hold the Alt key down and type 0174.

This post came about because I was searching for ways to create a copyright symbol for a batch of graphics in Photoshop.

Source: How to Create Copyright and Trademark Symbols via Keystrokes